This range of standard parts is made of die cast zinc with
black or silver matt textured powder coating. These
standard parts are fastened to frames or panels using
screws. Rubber inserts and spacer sleeves ensure a
positive connection when clamping to glass and plastic
panels that is nevertheless free of tension. The
additionally available T-slot nuts also allow the hinges
and clamps to be affixed to all typical aluminum profiles
of the B and I series.
The hinge GN 938 with a swiveling range of 180 degrees
is available in two sizes: 92 x 60 mm for panels from 4 to
8 mm thick and 122 x 90 mm for panels from 8 to 12 mm
thick. Thrust washers and hinge pins of non-rusting
stainless steel ensure a smooth and low-wear swivel
motion. The easily affixed zinc die cast covers hide the
fastening and clamping screws.
More information on Ganter standard parts can be found on the internet
at ganternorm.com